JetCat P90 RXi Turbine - Brushless
This new design of the JetCat RXi turbine incorporates an optimized compressor/diffusor system, resulting in higher engine performance and reliability. The Jetcat RXi follows throttle commands almost without delay.
Internal kerosene start
Internal EGT sensor!
Internal solenoids, only one fuel connection to the engine
Internal Brushless fuel pump
Bubble Detector Technology (on all RXi Models)
Single wiring connection from ECU to engine
New miniature/lightweight ECU V10.0
Battery: 3-cell LiFe (e.g. A123)
Weight: 1435gr (3.12lbs)
Thrust: 105N (24lbs) @130000 rpm
New Jetcat ECU V10.0
The completely redesigned V10.0 ECU is three times smaller than the V6.3 ECU, yet has all its proven capabilities and more.
The new ECU comprises a high speed digital power bus for control and power supply of all engine peripherals (e.g. engine, fuel pump, solenoids, smoke pump, lighting systems, etc. ) with a minimum of wiring connections.
An on board precision pressure and ambient temperature sensor allows for optimum engine control, independent to environmental conditions.
New JetCat Mini-GSU
The JetCat Mini-GSU is an optional miniature Ground Support Unit (GSU). It comprises a 2x16 character alphanumeric backlit LCD display and 10 control keys.
Function wise it can be used as a 100% replacement for our normal GSU. Its small form factor and weight makes it ideally suited for permanent installation in the model.
Connection to ECU`s up to Version 6.0 is via a 8-pin miniature flatcable connector directly to the LED-I/O interface.
Connection to ECU`s from Version 10.0 is via a 6-pin miniature flatcable directly to the ECU or the LED-I/O interface.
Or 8-pin flatcable to JetCat I/O-interface with charging option.
Mini GSU option available, contact for pricing and availabilty.