MEDIUM Connection Set
Set for easy mounting and contacting the MEDIUM DIY set. The set includes safety mounting plates, which, in addition to the mechanical mountings, contain a second circuit with a red and a green limiting light. Thus, in case of a defect still the fundamental position recognition remains, a new safety feature for the night flight!
uniLIGHT Night Blades
Compact size with maximum performance
Lowest impact on flight behavior
New cable and plugless installation
Optimized, adjustable cooling reflector
5 sizes for all standards
especially for wings and symmetrical for the tail unit
Asymmetric design for maximum ruggedness
Safety holder with position light available
large systems as cable and autonomous battery version
Assembly and operation
First, the enclosed, small contact plate is firmly glued into the edge of the wings, sides or on the elevator, preferably with good epoxy and optional pinnacles. Make sure that the writing on the contact plates is readable so that the polarity is correct. In the top view, right is always plus.
The connection cable is guided centrally within the surface to the fuselage. All Night Blades can simply be operated in parallel on a 2S LiPo battery or on any uniLIGHT lighting control. Pay attention to the zuelssige current load and sufficient battery capacity, a shutdown at deep discharge could be fatal at night!
For commissioning, the Night-Blade is simply placed on the mounting plate with the two screws and tightened, the electrical contact succeeds automatically. Make sure that the labels are always readable.
The reflector surfaces are bent once so that the largest possible part of the light emission is directed to the model. ATTENTION: the reflector surfaces harden and can only be bent a few times. Fix the glued surface before you align the surfaces by hand or a small pliers to prevent breakage of the splice.
After the flight, the Night Blades can simply be unscrewed and easily transported. There is no trace left of the night flight system.
Construction: 1.5mm fiberglass carrier
Overall size: 7.5x57 / 80mm
Delivery: three mounting plates for the wireless connection of two wing blades and a tail blade, 1m connection cable, ready-made for direct operation on 2S LiPo and any uniLIGHT light control