Pro-Drive Gemini Electric Retract Set PRO
Dreamworks is pleased to present our Pro-Drive electric retract systems. Over a year in development, our new electric series retracts and control modules are the most advanced electric gear systems available. Using our highly regarded Pro-Link retract units, we developed a strong and reliable drop-in electric drive actuator along with two distinct versions of our gear system control module.
All the features of our Taurus Series with modified frames to provide a smaller footprint at the rails.
The "PRO" system includes our durable T6 Gemini series retract frame and trunion, our Pro-Drive Gemini specific actuators and our feature packed "PRO" system control module. Our PRO Control System offers a host of features over our "Basic" module.
-Control by Single channel (Gear operation and brake operation combined on single channel) or separate channels for gear and brake.
-Control 3 landing gears. Programmable independent delay for each gear in UP and DOWN sequence.
-Control of electric brake:
- Proportional and adjustable maximum brake force
- Continuous operation or pulsed mode for "ABS" effect, 10 levels of pulse ratio.
- Brake Limiter to set max brake force
-Control of steering servo
- Allow to use same channel as the rudder despite different center, independant travel gain and direction on steering servo from rudder servo. The steering servo center, travel and sense of movement can be adjusted.
- The steering servo is centered and deactived during gear operation and gear UP phase.
-Door control output:
- 3 independent servo outputs for door control.
- Each output can be programmed in 3 different positions (Gear UP, Gear Down and Gear Moving phase).
- Servo Switch-off. Door servos can be deactivated after movement to prevent the posibility of servo burnout on a jammed door. Deactivation time can be programmed.
- Provides the ability cycle the gear manually for testing during setup phase, movement can be stopped and reasumed in any position.
- Each drive motor can be independently run in any direction and stopping in any position for checking clearance, etc.
- Cycle counter for scheduled maintenance.
-Easy setup: All adjustments are done through a Xicoy data terminal (not included).
-Electronic switch for the main battery.
- The unit can be programmed using the onboard LED and switch like our Basic controller (options limited using this program method)
- Data terminal for full programming not included. Compatible with all Xicoy SBus style data terminals used with Xicoy brand ECUS.
All Taurus Series Retracts are reversible!
- Three Pro-Drive Gemini Series Electric Retracts
- "PRO" Sequencing Control Module
- Steering Tiller Assembly 1/4" Pin
- Three Male-Male Module to Rx Leads
- Instruction Manual
- Length - 4.125" (105mm)
- Frame Width - .88" (22.3mm)
- Depth - 1.25" (31.75mm)
- Frame Rail mount length - 1.75" (44.45mm)
- Frame Rail Mount Width - 1.75" (44.45mm)
- 90 Degree Extension
- 1/2" Trunion (1/2" Strut Mounting)
- Cut Off Amperage - 1.5A
- Operating Votage - 6V to 10V
- 5.25" long 3.1oz strut, weight loaded at the axle - Stall was achieved at 38oz (2.375lbs, 1077g)
- 8" long 6oz strut, weight loaded at the axle - Stall was achieved at 17.3oz (1.08lbs, 490.44g)
- Transit time is roughly 6 seconds.